Someone prior to us has replaced all the receptacles with grounded ones even though there is no ground. The light did not light up on the switch and it did not respond if you tried to turn it off or go into the settings. That is were you may find the bare cooper ground lead for the replacement wall switch (4th wire). However, if the GFCI outlet is installed in a metal outlet box then a wire may be installed from the ground terminal of the GFCI outlet and bonded to the metal outlet box. I hooked my switch up and my box had no ground/green wire in it or a screw to attach a ground. The second solution to the problem is to wire the ceiling fan without the ground. It has the older 2 conductor copper wire with no ground. Seems very lazy to me. The grounding wire is the independent equipment ground, which is there in case there is a line to case fault, in which case a metal case could become live, and the IEG is there to safely conduct the current and minimize the potential for you to get a shock. When a 2-wire circuit does not have a ground wire and a GFCI outlet is installed nothing should be connected to the ground terminal. Also, if this subpanel has no ground wire in the feed, the neutral bar needs to be bonded to the panel and the lone ckt ground moved to the neutral bar. I loosened the screws but the wire wouldn’t come out. If the original fan light switch did not use the ground (3 wire) then the electrician would just shove the ground wire deep back in the box. Pull it out and ground the new wall switch. Look with a flashlight into the back of the plastic box. The ground wire must go back to the same panel as the conductors come out of (that's relevant if you have more than one panel). If you have METAL outlet boxes, it was acceptable at one time to attach a ground wire to the box, then when you attached the receptacle to the box, it was grounded. Is it common for an installer to put in light switches without attaching the ground wire? That is no longer allowed though, you must attach the ground wire to the device and have a "pigtail" that attaches to the box. The box is actually metal. Also, should I go through the entire house and attach the ground wires? Definitely do not attach the ground wire to the neutral. Also, there are numerous splices in the attic w/ electrical tape and no jboxes that I have been redoing w/ jboxes and wire nuts. When I turned the power on the lights came on and the switch did not work at all. The bare ground wire connects to any conductive material, like the metal yokes on the recepticals and switches with the green ground screw and runs back to the ground bar in the service panel and then, most likely to grounding rod(s). There's just so much paint on it, it's hard to tell. ... As the blue boxes are plastic, there is no need to ground them. It makes no sense to install a ground bar if the panel is fed with a neutral & no ground unless the neutral bar is full. The ground wire doesn't carry any electrical current (unless there is a problem in your electrical system). I’m assuming it’s attached to the switch itself and that I’ll need to cut the wire. The box they are in is plastic. Also are there switches where the wire is part of the switch. Is it okay to not ha e a ground in the new light switch? So once I find the ground, I assume that I wirenut all three ground wires together?

How To Make A Simple Generator, The Beautiful Names And Attributes Of Allah Uthaymeen Pdf, Grammar And Beyond Answer Key, Is Bf3 Polar, Chrome Cologne Legend, Where Can I Buy Tartufo, Gabriel Phthalimide Reaction, How To Cook Collard Greens And Cabbage With Ham Hocks, Spell Dr Seuss, Granby Ranch Camping, Landlord Lost Key Charge, Rick Bayless Cookbook, Math Study Guide Template, Balsamic Meaning In Sinhala, How To Pronounce Tusk, How To Draw A Whole Watermelon, Easy Canvas Prints 16x20, Let Them Meaning In Telugu, Tamarind Vitamin C, Aluminum Frying Pan Reviews,

Leave your comment